Pack of 2 X AutoPot foam pads (includes shipping).
This product is designed for plants that do not like wet feet or for use when there is too much rain when grown outside.
The idea is simple - it lifts the bottom of the pots by 25mm (which is just about the maximum level set by the Smart-valves) and yet water supply to the pot plant is being maintained by the wicking action of the mat attached to the foam unit. The foam pads also displace the water from the Hydrotray by as much as 80% which means there is quicker water change in the tray.
Suitable for both 10" Hydrotray Double 10" modules or the Hydrotray Single 12" module (ensure your 12" pot has holes at the base in order to contact the foam pad - if not, you will need to drill some holes for water transmission).
Installation is easy. Step 1 & 2, insert the strip of mat through the centre slot of the foam piece. Step 3 - Soak the foam pad in water before placing it into the Hydrotray as shown. Step 4 - Sit the pot directly on the foam pad.
Few Important Points
1. It is vital to soak the foam pad with water before use, otherwise it may not draw water properly.
2. Some growing media works better than others. The best bet is to use potting mix and/or perlite/vermiculite mix. Loose growing media such as 100% perlite or scoria are not so suitable as they do not conduct water properly through the felt mat.
3. You can stack more than one pad if you wish to give your plant a dryer condition.
AutoPot's 35 Litre tank - comes pre-drilled with a grommet at the base.
Used for gravity feeding your AutoPot modules. The addition of a filter is recommended.
Hydrotray Double 10"