Skip to content
MON-SAT 9AM-5PM SUNDAY 11PM-3PM CLOSED PUBLIC HOLIDAYS
Hydrotray Double 10" Module
Hydrotray Single 12" Module - Black
Hydrotray Single 12" Module - Green
Hydropak Starter Kit
8 Pot Kit
Intermediate (20 pot) Kit
Window Box Kit
Smart Pump Set
Twin Wall Planters
Mini Twin Wall
Twin Wall planter
Hydroponics Made Easy - by Jim Fah
Hanging Basket Rings
Root Control Mats
10" Pot Marix
12" Pot Marix
6" Pot Marix
CapPlus Table Marix
12" tray insert
Taps, Joints, Filters and Misc
Window Box Hook On Brackets
Taps, Joints, Filters and Misc
Price: Low to High
Price: High to Low
30 per page
60 per page
120 per page
180 per page
300 per page
Grommet - for 4mm tubing
4MM STRAIGHT JOINT
4mm grommet for nutrient tanks or any container where you want to run a 4mm tube from.
Drill a 10mm hole and insert tubing straight in - for a more secure fitting, use a 4mm barbed straight joiner with 2cm of tubing on one end and apply pressure when inserting.
PACK OF 10 - 4MM STRAIGHT JOINTS FOR 4MM TUBING
PACK OF 10 - 4MM T-JOINTS
13MM RACHET CLAMPS
13MM TAP FOR 13MM TUBING
*price includes shipping
PACK OF 20 - 13MM RACHET CLAMPS FOR 13MM TUBING
PACK OF 10 - 13MM T-JOINTS
4mm in-line filter
Tubing - 4mm x 10m
4mm in-line mesh filter.
Works in both directions.
Soft 4mm Tubing x 10 meters.
Used for all AutoPot modules.
Replacement check valves for the AutoPot Smart Pump Set.
13MM TO 4MM REDUCERS
13mm -> 4mm reducing filter
PACK OF 10 13MM TO 4MM REDUCERS
Pack of 100 Tomato Clips, also idea for sweet pepper, cucumber, eggplants and other vine plants.
A filter with a removable mesh inner for cleaning.
This filter has 13mm connections PLUS additional 4mm screw on adaptors that convert the filter to a 4mm filter. You can use this as a 133mm filter, 4mm filter or as a reducing fitting (13mm tubing or grommet filtered down to a 4mm outlet - ideal for aquaponics applications to reduce blockages on drip lines).
The 4mm barbs feature the white screw on caps which lock the tubing in place.
13mm -> 4mm cross with screw capped barbs (5 pack)
Reducer fitting in a cross configuration.
For 13mm tubing reduced down to 4mm.
Fitting has barbs for the tubing, which is then secured with a screw cap.
As used in Jim Fah's commercial farms for a more secure fitting to handle pressure and reduced leakages.
Pack of 5.
* Use with green blanking knobs to close off any unused 4mm outlets
PACK OF 10 - 4MM TAPS FOR 4MM TUBING
15psi pressure regulator for restricting outlet pressure. Recommended as a safety for the AutoPot Smart Pump Set mains inlet, or connected to a timer for direct watering from the mains to an AutoPot module.
3/4" BSPF inlet x 3/4" BSPM outlet.
Price includes shipping Australia-wide.
Pressure gauge 0-30psi
HOT/COLD Thermal Controller
A useful accessory when using the pump set or a pressurised system - good for checking the pump's operation and cut-off pressure.
Includes adaptor and 4mm tubing to install to the main feed line.
Replacement damper for the smart pump set
Used to control the operation of the heat cord in the heated CapPlus table. Set the desired temperature (measured at the probe) - if the temperature drops below set point, then the heater is triggered.
Can also be used to trigger a cooling device e.g. a fan - if temperature rises above set point.